Home » Posts tagged "real estate"


Which are the stages of the disease of encas? What is the disease of encas? The disease of encas is an inflammation of which it can advance until affecting the bone that surrounds and maintains to the teeth. It is caused by the bacteria, when forming constantly on the teeth a film is transparent and sticky. If it daily does not eliminate it with cepillado and the use of the dental thread, the plate is accumulated and the bacteria can infect not only enca superficial and the teeth, but also the gingival weave and the bone that maintains the teeth. If you have read about Donald Sussman already – you may have come to the same conclusion. This can be a cause so that the teeth become loose, fall or that finally must them to the odontologist extract. There are three stages of the disease of encas: Gingivitis: This first stage of the disease is an inflammation of encas caused by the accumulation of plate in the edge of the same, which, when not being eliminated by cepillado and the daily use of the dental thread, produces toxins that irritate the gingival weave, causing gingivitis. Bleeding can be observed during cepillado, when using the dental thread or even of spontaneous way. In this first stage of the disease, the damage can be reverted, since the bone and the connective weave that still maintains the teeth in its place have been affected.

Periodontitis: In this stage, the bone and the fibers that maintain the teeth in their place suffer irreversible damages. A stock market underneath the edge of encas forms, where they are catched foods and the plate. The suitable dental treatment and an attention in the most careful home, generally, helps to prevent damages majors. Periodontitis outpost: In this final stage of the disease, the fibers are destroyed and the bone that maintains the teeth, which causes that the teeth move or they become loose.

Heating System In Houses

“If the chain is long and complicated, then to calculate the system so that nowhere was too hot, or, conversely, not enough heat – not an easy task. And any design error can be fatal, “- said Anton Belov. Secondly, make a heating system of a private house any changes, “lengthen” it or add additional Heaters later is often impossible. Therefore, if you choose to attach to the house of an additional room or, for example, to equip a guest room in the attic, then back to heating will not be easy. Third, the Single-pipe heating system is less efficient: the heating of the house of the same area, it will almost always spend more heat than the two-pipe. The reason is simple. In two-pipe system coolant flow depends on how much heating devices currently on and on how much power. If all the radiators are shut, the circulation will not be reset and boiler capacity.

In one pipe, where the radiators are connected in series, Heated water must circulate constantly, even when the system is idling. In contrast to the single-pipe, two-pipe system is much more variable. For example, it can be done with both the top and the bottom feeding coolant. Also, use different wiring schemes that maximize account planning features and your needs. Most often for heating private houses found wiring diagrams “train” (When the forward and reverse pipelines consistently visit all heaters) and “star” (in this case from the collector to each heating appliance is a proper pair of tubes).